Surface Mount Bollard Installation Guide

Surface Mount Bollard Installation Guide


1. Prepare all the necessary equipment needed to install your bollard. Make sure that you have these things:

  • A hammer drill with masonry drill bit that suit your fixings’ size
  • Bollard fixings (We give free fixings in every purchase)
  • Hammer
  • Wrench or Socket wrench
  • Industrial vacuum or a simple hand broom

2. Before starting the actual process, make sure to read thoroughly the installation guide and steps.

3. Identify the area you wish the bollards to be placed. If you will install more than one bollards, make sure to mark each specific area in order to align the bollards properly. It is advisable to leave 1500mm/1.5m space in between each bollard when installing.

4. Carefully place the bollard where it should be positioned and mark each hole using a smaller bit of hammer drill. This is to make a centre drill that will guide you where to use a larger drill.

5. Remove the bollard and place it back to a safer place to avoid any damages. Clean the surface with either a vacuum or broom to brush away dust.

6. Start a larger drill on the guide hole you created earlier. Keep on drilling up to approximately 120mm depth.

7. After drilling, again, clean the surface to brush off concrete dust.

8. Now, put the leg bolts into the hole and start to hammer it down.

9. Then, place the bollards on the surface again with its hole aligning properly with the leg bolts.

10. Now, put the screws through the bollards and on the leg bolts, then start to tighten them all using a wrench. Make sure that the screws are not overly tightened.

Following these simple and easy steps will surely help you maximize the best protection a bollard can give. On the other hand, your safety is still our first priority so make sure to wear safety gear before to start this process and to avoid any unwanted injuries.

Please call us at 1300 201 337 or email us at for Installation Dat Sheet or Formal Quote.


Additional information