Wheel Stop Installation Guide
Position the Wheel Stops according to Standard AS/NZS 2890.1:2004 [As measure from the front of the car park kerb or wall]
- Standard kerb up to 150mm High [Front In: 620mm / Rear In: 900mm]
- High Kerb or wall higher than 150mm [Front In: 820mm / Rear In: 1100mm
Fixing Wheel Stop to asphalt / bitumen surfaces over metal base-course
- Position Wheel Stop according to the setting our standard above
- Use our 300mm x 12mm Asphalt Spike as supplied
- Use 10mm masonry drill to drill a hole 220mm deep into the base course
- Use a club or sledge hammer to drive the 12mm pin though the Wheel Stop into the base-course
- take extra care driving the pins into the recessed hole to prevent overstrike damage to the Wheel Stops
Fixings Wheel Stop to concrete Surfaces
- Position Wheel Stop according to the setting our standard above
- Use our M16 x 135mm sleeve anchor as supplied
- Use a 16mm masonry drill to drill a hole 60mm deep hole into concrete
- Blow out the dust with compressed air
- Tap in the sleeve anchor into the recessed hole and tighten
Fixings Wheel Stops over pavers
- Use our 300mm x 12mm Asphalt Spike as supplied
- Use a 12mm masonry drill to drill 12mm hole right through the paver, 220mm deep
- use a club or sledge hammer to drive the 12mm pin through the paver and into the base-course
- Take extra care when driving the pins ito the recessed hole to prevent overstrike damage to the Wheel Stops
Please call us for Wheel Stop Installation Data Sheet.
